Lokring Connector Sealant Sealing liquid

• 50ml per bottle,can be used on about 300pcs small diameter lokring fittings;
• Usage: The sealant is always used to be filled when using lokrings and single rings when crimping copper, aluminum and iron pipes with solderless connection method.
• The lokring sealing liquid is non-toxic, non-polluting, and will not corrode metal piping of any material.
• It is available in a wide temperature range of -50°C to +150°C.

• The sealant is available for retail and wholesale;
• The place of origin is in China,when you buy one or two,please consider freight(by air or by sea) into the cost;
• Accept bulk order with Container delivery;
• Please contact us online (click here) Or send inquiry message to our email:  sale@smartclima.com or hvac@smartclima.com

The sealant is suitable for the installation and maintenance of all refrigeration products. It can be quickly filled when using lokrings and single rings when crimping copper, aluminum and iron pipes without welding tools. Special note: The sealing liquid is not glue, without any viscosity, it is a polymer filler, and it is a consumable for crimping pliers to crimp single rings and lokrings. A single sealing liquid cannot be used to seal pipes. 50ml per bottle.

Since the sealing fluid is used to fill the scratches and tiny sand pits on the surface of the pipe, it is not the glue that sticks the two pipes that need to be connected together. The sealing liquid has been widely recognized in almost all refrigeration industry fields. It has a good sealing effect and will not chemically react with the refrigerant; the molecular structure is stable, it will not dry and brittle into powder, and it will always maintain a soft and uniform film; adapt to The temperature range is wide, meeting the ambient temperature requirements of most refrigeration products. The storage ambient temperature is 5-25°C, in a ventilated place, not exposed to the sun, and often open the bottle for inspection.

The curing time of the sealing liquid varies with the metal material in contact with and the ambient temperature of the site . Specifically, as long as one end is a copper tube, the curing time is about 2-4 minutes. If both ends are aluminum tubes, the curing time is about 15 minutes at 20-25°C . If the ambient temperature is too low (below 10°C), the curing time will be longer. If necessary, the crimped joint can be properly heated to accelerate curing. The heating temperature should not exceed 48°C.

*Precautions
Do not use expired sealant. Store at an ambient temperature of 5-25 ° C.
If the sealing liquid drips on the refrigerator liner, it needs to be cleaned with a rag or paper towel.