Models & Details for “Digital Thermostat Module Model XH-W1219 ”
How to operate:
How to recovery to initial value? In normal power state, while holding down the + – button for about three seconds to restore the factory settings
PO thermostat mode This value must be set when the thermostat is used for the first time.If it is used for heating, it should be set to H. If it is used for cooling, P1 hysteresis setting Press the SET button to enter the internal settings, select P1 settings, and then press the SET button to set the value of hysteresis. (Hysteresis is when the thermostat reaches the set temperature after the stop, the difference in the need to work again, such as we set the heating mode, heated to 40 degrees to stop 35 degrees to start again, the hysteresis is 5) P2 temperature calibration This function is used for temperature calibration, if the detected temperature and the actual temperature deviation can be used when this function correction, the value of correction = measured value + correction value, For example, we measure the temperature of 25.6 degrees and 25.8 degrees is actually the P4 can be set to o.2, then the final temperature is 25.6 +0.2 = 25.8 P3 delay start This function is generally used for compressor refrigeration, if you buy this thermostat for the refrigerator freezer then this value is must be set according to the compressor back pressure is generally set the value of 3-6 minutes, if you are not control the compressor Or do not need to delay the function directly skip this. P4 high temperature alarm Set the high temperature alarm value, when the real-time temperature exceeds this value, the screen will flash prompt alarm! Heating mode setting sample; Control heating equipment heated to 35 ℃ to stop heating, when the temperature drop to 30 ℃ again to start the equipment heating, how to set? Long-time Press the SET button for 3 seconds to enter the internal settings, the PO is set to H; Long-time Press the SET button to return to the real-time temperature interface, press the SET button green digital tube flashing, the value is set to 35 ℃; The factory default hysteresis is 2 ℃, in order to reduce the temperature to 30 ℃ ,then heating again, you need to set return value to 5. Long-time press the SET button to enter the internal settings, select P1, change P1 value to 5, The setup is complete.
Cooling mode setting sample: Control cooling equipment cool to 23℃ to stop cooling, when the temperature rise to 27℃ again to start the equipment cooling, how to set? Long-time Press the SET button for 3 seconds to enter the internal settings, the PO is set to C; Long-time Press the SET button to return to the real-time temperature interface, press the SET button,the green digital tube flashing, the value is set to 23℃; The factory default hysteresis is 2 ℃, in order to rise the temperature to 27℃ ,then cooling again, you need to set return value to 4. Long-time press the SET button to enter the internal settings, select P1, change P1 value to 4, The setup is complete.
Buying Guide to “Digital Thermostat Module Model XH-W1219”
The Digital Thermostat Module Model XH-W1219 is available for retail and wholesale;
Accept customized bulk production,putting your logo;
The place of origin is in China,when you buy one or a small quantity,please consider freight into the cost;
Accept bulk order with Container delivery;
Please contact us to email: econtrol@smartclima.com or sale@smartclima.com ,we can supply a favourite item you need.
Be the first to review “Digital Thermostat Module Model XH-W1219”