Digital Thermostat Module Model XH-W1209 temperature controller
Sell Digital Thermostat Module Model XH-W1209 temperature controller yo keep your refrigeration device at a set temperature range,set range is from -50℃ to 110℃.It is used in HVAC system.
Place of Origin:
Direct-sale by China Manufacturer.
Sell to worldwide, Ship by air plane or by sea boat;
Models and Details for “Digital Thermostat Module Model XH-W1209 temperature controller ”
Model:XH-W1209 Thermostat Range: -50℃ to 110℃ Thermostat Accuracy: 0.1℃ Power Supply: DC12V Output: 1 output Max 10A relay. Size: 48x40mm
Options:
12V / red light /with 1meter probe 12V / blue light / with 1meter probe 220V / red light /with 1meter probe 220V / blue light/with 1meter probe
Features:
1,100% complete machine chip, wave soldering, stable performance, good consistency; 2, embedded central processor chip (MCU), better intelligent, lower power consumption; 3, power-off settings automatically memory (MCU built-in EEPROM storage unit) 4, the control accuracy of 0.1 ℃; 5, hysteresis 0.1 from the set, you can control the decimal (0.1-15.0)
Technical parameters Thermostat range: -50 ~ 110 ℃; Resolution: 0.1 ℃ between -9.9 ~ 99.9 ℃; 1℃ at other range; Temperature measurement accuracy: 0.1 ℃; Control accuracy: 0.1 ℃; Backlash accuracy: 0.1 ℃; Refresh rate: 0.5 S; High Temperature Alarm: 0 ~ 110 ℃; Motherboard Power Supply: DC 12V; Output: 1 channel relay output, capacity=10A; Measurement input: NTC (10K 0.5%) Waterproof sensor; Environmental requirements: -10 ℃ ~ 60 ℃, Humidity 20% -85%; Size: 48 * 40mm; Power consumption: Quiescent Current: ≤35MA;Attract current≤65MA;
How to operate: After wire ,then can supply power to the device, display ambient temperature.Press SET key a time,screen flash the temperature.press key of + – to set the desired temperature. (long-time to press key of + – to get a quick setting). after set the temperature,press SET to confirm and return, then the controller automatically do power- on or power-off Relay.The thermostat output 10A relay to meet a variety of high-power load, please sure to connect the correct circuit. Indicator light, digital tube and buzzer status Indicator light: Flashing indicates the cooling or heating delay-start . If the indicator is on, it indicates that the relay is closed Digital tube: display “LL” means sensor is connected; display “HH” means over the measuring range,then the thermostat is force to disconnect the relay; display “—‘ means high temperature alarm.
Long-time press SET ket 5 seconds,then enter main setting menu,press + – key to change P0 to P8.Long-time press SET key or no any press 10seconds,automatically confirm and return.
Code
Indicating
Set range
Inital Setting
P0
Mode set(Heating or Cooling)
C/H
C
P1
Set return difference
0.1-15
2
P2
Up limit
110
110
P3
Down limit
-50
-50
P4
Temp. Adjust
-0.7-7℃
0
P5
Delay start time
0-10 minutes
0
P6
High temp.alarm
0-110℃
off
At “OFF” state, Long press + -,start and then recovery to inital set
Write enquiry message or review