- The item is available for retail and wholesale;
- The item takes large packing dimension,therefore,takes much volume weight.The place of origin is in China,when you buy one or two,please consider freight(by air or by sea) into the cost;
- Accept bulk order with Container delivery;
- Pls indicate us the quantity you need,so that we can calculate the shipping charges;
- For purchasing or other more requirements, Please contact us to email: firstname.lastname@example.org
General Knowledge on “Air deflector for vertical wall Louver air grille”
A story: Mike keeps always healthy and never got sick. But after he move the desk close to air conditioner vent mouth,he always get sick,suffering much variations,for example the flu and sinus issues,etc. He thought it may cause the air condition airflow blowing directly onto his body and face. Then Mike check the reason on internet and found many sample men like him.nad finally,he brough a deflector installed under the indoor unit,Change the airflow to let cold(warm) diffuse evenly in the room.And now,he keeps health always again!
And then,How the deflector works on air conditioner?
First,indoor air is generally divided into three layers, which are “ground thermostat layer, the middle mixed layer and the upper layer of heat accumulating . The installation position of air conditioner indoor unit is generally in upper layer of heat accumulating . Due to the physics principle of cold air is strong but heat air is weak,the cooling air from indoor unit is directly down to the ground thermostat layer through the middle mixed layer of the heating and cooling .Therefore, the air at the lower layer is cooled rapidly, the cooling air is accumlated from the below to up,to let human feeling cool.
(Without Air Baffle For Air Conditioner)
But the cooling for the upper layer depends on the radiation of cooling air from below layer. The radiation is no good effect because there is no rapid exchange between upper layer and ground layer.Also,because of the continued invasion from the outdoor heat , resulting in the slow temperature drops in the upper layer. Therefore, the air conditioning is switched on for a long time cooling state, even if the indoor air temperature is already low.
This is the present situation of the existing split wall-mounted air conditioning running.
The air baffle for air conditioner made by Smartclima overcome the above phenomenon through to install an air-way panel at the outlet of the indoor unit, to change/adjust the angle of outlet cooling air. of the air guiding cover. Because of the use of air baffle,the cooling air will not be directly blown onto the body. Through the living hinge of the wind guide panel to adjust the orientation of the air stream, in order to adapt to different needs; At the same time, since the cold air is guided to upwardly, so that cold air is first blown to the upper layer of heat accumulating, firstly to mix the upper heat air,and then the mixed air is recycle from the top to down,which way is following the priciple of the exchange between heat and cold,by the above way,it improve the overall cooling efficiency of the indoor air. The refrigeration cycle mode mentioned can make the room air at up and below keeps very small temperature difference, therefore it can reach air conditioning seted temperature in fast, to shorten the running time of the air conditioner able to achieve energy saving.
(After use Air Baffle For Air Conditioner)
(Save 10% energy of electricity because of air baffle for air conditioner!)
After several tests, compared the test result of the air conditioning seted temperature from 22 to 26,we know it can save energy about 10% after using air baffle.
Below is test data:
(Given below test data is for reference only)
(1)using air conditioning without baffle
Test Date: August 2, 2008
Test environment: 20 square meters bedroom, 12000BTU wall-mounted air conditioning (power 1.2 kW), the outdoor maximum temperature of 34, minimum temperature 22 (outdoor temperature from the day weather forecast) test time 24 hours, start testing time 10:00 start testing the indoor temperature is 29; air conditioning seted temperature of 25, automatic swing wind.
Test results: air-conditioned first downtime 11:32, total power consumption of 18500W..
(2) using air conditioning with air baffle
Test Date: August 8, 2008
Test environment: 20 square meters bedroom, 12000BTU wall-mounted air conditioning (power of 1.2 kW), the date of the outdoor maximum temperature of 34 minimum temperature 24, 24 hours of test time, starting test time 10:00, start testing indoor temperature 29; air conditioning set temperature of 25, automatic pendulum Wind.
Test results: air-conditioned first downtime 11:10, total power consumption of 16500W.
After use air baffle ,can save electricity (18500-16500)/18500 = 10.8% !
Description: The air-conditioning seted to 25,as example, because it is the best temperature for human feeling and energy-saving effect of contrast.